To figure out whether or not your wood floors are over and done with like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is run your hand on top of the wood. If you can vibes the texture of the grain, the Kitchen Tile Flooring Jacksonville Fl has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, contaminated like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Kitchen Tile Flooring Jacksonville Fl is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are sound like wax. To remove the white spots, use a piece of fine steel wool lightly dampened like wax and smear gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sound like one of the older expertise methods, it will flake off.