To figure out whether or not your wood floors are over and done with as soon as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is control your hand more than the wood. If you can air the texture of the grain, the Laminated Wood Flooring Za has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, contaminated as soon as additives for drying) topped as soon as wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, as soon as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Laminated Wood Flooring Za is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after very nearly 10 to 15 minutes, the floors are unquestionable as soon as wax. To remove the white spots, use a piece of good steel wool lightly dampened as soon as wax and smear gently. The last is if you suspect a varnish or shellac, receive a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been unquestionable as soon as one of the older talent methods, it will flake off.