To figure out whether or not your wood floors are done behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is direct your hand greater than the wood. If you can character the texture of the grain, the Oc Kitchen And Flooring Yorba Linda has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, polluted behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Oc Kitchen And Flooring Yorba Linda is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are hermetically sealed behind wax. To remove the white spots, use a fragment of fine steel wool lightly dampened behind wax and smear gently. The last is if you suspect a varnish or shellac, agree to a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed behind one of the older expertise methods, it will flake off.