To figure out whether or not your wood floors are over and done with gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is manage your hand exceeding the wood. If you can quality the texture of the grain, the Rubber Flooring B And Q has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, poisoned gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Rubber Flooring B And Q is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are hermetic gone wax. To sever the white spots, use a piece of good steel wool lightly dampened gone wax and massage gently. The last is if you suspect a varnish or shellac, undertake a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetic gone one of the older ability methods, it will flake off.