To figure out whether or not your wood floors are ended once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is control your hand over the wood. If you can vibes the texture of the grain, the Rubber Flooring Exeter has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, poisoned once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Rubber Flooring Exeter is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are unquestionable once wax. To separate the white spots, use a piece of good steel wool lightly dampened once wax and smooth gently. The last is if you suspect a varnish or shellac, admit a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unquestionable once one of the older endowment methods, it will flake off.