To figure out whether or not your wood floors are curtains in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is direct your hand on top of the wood. If you can feel the texture of the grain, the Rubber Flooring Hardwood Look has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, unclean in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish on the Rubber Flooring Hardwood Look is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are solid in imitation of wax. To separate the white spots, use a piece of good steel wool lightly dampened in imitation of wax and smear gently. The last is if you suspect a varnish or shellac, recognize a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid in imitation of one of the older endowment methods, it will flake off.