To figure out whether or not your wood floors are the end considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is rule your hand more than the wood. If you can setting the texture of the grain, the Rubber Flooring Home Depot has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, impure considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Rubber Flooring Home Depot is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after not quite 10 to 15 minutes, the floors are strong considering wax. To sever the white spots, use a piece of good steel wool lightly dampened considering wax and rub gently. The last is if you suspect a varnish or shellac, say yes a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong considering one of the older achievement methods, it will flake off.