To figure out whether or not your wood floors are finished afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is run your hand higher than the wood. If you can atmosphere the texture of the grain, the Rubber Flooring Japan has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, infected afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Rubber Flooring Japan is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after roughly 10 to 15 minutes, the floors are sealed afterward wax. To separate the white spots, use a fragment of good steel wool lightly dampened afterward wax and smear gently. The last is if you suspect a varnish or shellac, agree to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been sealed afterward one of the older endowment methods, it will flake off.