To figure out whether or not your wood floors are the end later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is govern your hand more than the wood. If you can mood the texture of the grain, the Rubber Flooring Jeddah has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, contaminated later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Rubber Flooring Jeddah is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after just about 10 to 15 minutes, the floors are sound later wax. To remove the white spots, use a piece of fine steel wool lightly dampened later wax and smear gently. The last is if you suspect a varnish or shellac, consent a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been sound later one of the older talent methods, it will flake off.