To figure out whether or not your wood floors are over and done with in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is run your hand greater than the wood. If you can feel the texture of the grain, the Rubber Flooring Lahore has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, polluted in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Rubber Flooring Lahore is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are unquestionable in imitation of wax. To separate the white spots, use a piece of good steel wool lightly dampened in imitation of wax and massage gently. The last is if you suspect a varnish or shellac, take a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unquestionable in imitation of one of the older finishing methods, it will flake off.