To figure out whether or not your wood floors are finished like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is control your hand over the wood. If you can tone the texture of the grain, the Rubber Flooring Las Vegas has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, infected like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Rubber Flooring Las Vegas is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are unassailable like wax. To remove the white spots, use a piece of fine steel wool lightly dampened like wax and smear gently. The last is if you suspect a varnish or shellac, say yes a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unassailable like one of the older realization methods, it will flake off.