To figure out whether or not your wood floors are over and done with once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is govern your hand higher than the wood. If you can quality the texture of the grain, the Rubber Flooring Los Angeles has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, infected once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish upon the Rubber Flooring Los Angeles is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are solid once wax. To separate the white spots, use a fragment of good steel wool lightly dampened once wax and rub gently. The last is if you suspect a varnish or shellac, take a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid once one of the older finishing methods, it will flake off.