To figure out whether or not your wood floors are finished similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is run your hand on top of the wood. If you can vibes the texture of the grain, the Rubber Flooring Walmart has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, dirty similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Rubber Flooring Walmart is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetically sealed similar to wax. To cut off the white spots, use a piece of fine steel wool lightly dampened similar to wax and massage gently. The last is if you suspect a varnish or shellac, recognize a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed similar to one of the older finishing methods, it will flake off.