To figure out whether or not your wood floors are done afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is manage your hand higher than the wood. If you can mood the texture of the grain, the Rubber Gym Flooring New Zealand has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, poisoned afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Rubber Gym Flooring New Zealand is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are sound afterward wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened afterward wax and smooth gently. The last is if you suspect a varnish or shellac, agree to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound afterward one of the older skill methods, it will flake off.