To figure out whether or not your wood floors are over and done with afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is manage your hand on top of the wood. If you can character the texture of the grain, the Tiny House Floor Plans Michael Janzen has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, infected afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Tiny House Floor Plans Michael Janzen is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after very nearly 10 to 15 minutes, the floors are unassailable afterward wax. To remove the white spots, use a fragment of fine steel wool lightly dampened afterward wax and smear gently. The last is if you suspect a varnish or shellac, resign yourself to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unassailable afterward one of the older exploit methods, it will flake off.