To figure out whether or not your wood floors are over and done with in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance center suggests these tests: First is direct your hand beyond the wood. If you can feel the texture of the grain, the Wood Laminate Flooring New Zealand has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, polluted in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Wood Laminate Flooring New Zealand is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after roughly 10 to 15 minutes, the floors are strong in the same way as wax. To cut off the white spots, use a piece of fine steel wool lightly dampened in the same way as wax and smooth gently. The last is if you suspect a varnish or shellac, acknowledge a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong in the same way as one of the older talent methods, it will flake off.