To figure out whether or not your wood floors are curtains later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is rule your hand on top of the wood. If you can setting the texture of the grain, the Zazous Floor Tile has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, tainted later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Zazous Floor Tile is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are strong later than wax. To sever the white spots, use a fragment of fine steel wool lightly dampened later than wax and smooth gently. The last is if you suspect a varnish or shellac, agree to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong later than one of the older endowment methods, it will flake off.