To figure out whether or not your wood floors are finished in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is direct your hand on top of the wood. If you can tone the texture of the grain, the Zen House Floor Plans In The Philippines has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, poisoned in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Zen House Floor Plans In The Philippines is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are solid in the same way as wax. To cut off the white spots, use a piece of fine steel wool lightly dampened in the same way as wax and rub gently. The last is if you suspect a varnish or shellac, recognize a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been solid in the same way as one of the older talent methods, it will flake off.