To figure out whether or not your wood floors are ended similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is govern your hand more than the wood. If you can character the texture of the grain, the Bathroom Laminate Flooring B And Q has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, contaminated similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Bathroom Laminate Flooring B And Q is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are sealed similar to wax. To sever the white spots, use a piece of fine steel wool lightly dampened similar to wax and daub gently. The last is if you suspect a varnish or shellac, take a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed similar to one of the older completion methods, it will flake off.