To figure out whether or not your wood floors are over and done with past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is control your hand over the wood. If you can air the texture of the grain, the Bathroom Laminate Flooring Home Depot has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, polluted past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Bathroom Laminate Flooring Home Depot is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are strong past wax. To remove the white spots, use a fragment of fine steel wool lightly dampened past wax and smooth gently. The last is if you suspect a varnish or shellac, assume a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been strong past one of the older carrying out methods, it will flake off.