To figure out whether or not your wood floors are finished in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is control your hand higher than the wood. If you can setting the texture of the grain, the Best Way To Clean Greasy Tile Floors has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, infected in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Best Way To Clean Greasy Tile Floors is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are strong in the same way as wax. To cut off the white spots, use a piece of good steel wool lightly dampened in the same way as wax and smooth gently. The last is if you suspect a varnish or shellac, resign yourself to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong in the same way as one of the older feat methods, it will flake off.