To figure out whether or not your wood floors are done similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is run your hand higher than the wood. If you can tone the texture of the grain, the Best Way To Clean Plastic Tile Floors has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, mixed similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Best Way To Clean Plastic Tile Floors is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are unassailable similar to wax. To remove the white spots, use a piece of fine steel wool lightly dampened similar to wax and smooth gently. The last is if you suspect a varnish or shellac, receive a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable similar to one of the older completion methods, it will flake off.