To figure out whether or not your wood floors are ended with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is rule your hand on top of the wood. If you can character the texture of the grain, the Best Way To Clean Stone Tile Floors has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, poisoned with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Best Way To Clean Stone Tile Floors is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are sound with wax. To remove the white spots, use a fragment of good steel wool lightly dampened with wax and smooth gently. The last is if you suspect a varnish or shellac, put up with a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sound with one of the older capability methods, it will flake off.