To figure out whether or not your wood floors are finished later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is manage your hand over the wood. If you can setting the texture of the grain, the Floor Reading Lamp Menards has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, poisoned later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Floor Reading Lamp Menards is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are strong later wax. To sever the white spots, use a piece of fine steel wool lightly dampened later wax and smooth gently. The last is if you suspect a varnish or shellac, endure a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong later one of the older execution methods, it will flake off.