To figure out whether or not your wood floors are over and done with in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is direct your hand exceeding the wood. If you can environment the texture of the grain, the Floor Tile Cleaning Central Coast has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, poisoned in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish on the Floor Tile Cleaning Central Coast is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are hermetic in the manner of wax. To surgically remove the white spots, use a fragment of fine steel wool lightly dampened in the manner of wax and massage gently. The last is if you suspect a varnish or shellac, tolerate a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetic in the manner of one of the older success methods, it will flake off.