To figure out whether or not your wood floors are done once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is rule your hand on top of the wood. If you can setting the texture of the grain, the Gym Floor Ecotile has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, polluted once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Gym Floor Ecotile is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are hermetically sealed once wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened once wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed once one of the older ability methods, it will flake off.