To figure out whether or not your wood floors are done behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is rule your hand over the wood. If you can environment the texture of the grain, the Gym Floor Tiles Cheap has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, polluted behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Gym Floor Tiles Cheap is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are solid behind wax. To surgically remove the white spots, use a piece of fine steel wool lightly dampened behind wax and rub gently. The last is if you suspect a varnish or shellac, assume a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been solid behind one of the older execution methods, it will flake off.