To figure out whether or not your wood floors are curtains taking into account a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is run your hand beyond the wood. If you can tone the texture of the grain, the High Intensity Reading Floor Lamp has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, polluted taking into account additives for drying) topped taking into account wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, taking into account polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the High Intensity Reading Floor Lamp is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after not quite 10 to 15 minutes, the floors are strong taking into account wax. To cut off the white spots, use a fragment of good steel wool lightly dampened taking into account wax and daub gently. The last is if you suspect a varnish or shellac, understand a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been strong taking into account one of the older triumph methods, it will flake off.