To figure out whether or not your wood floors are ended similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is run your hand over the wood. If you can quality the texture of the grain, the How To Clean Hardwood Engineered Floor has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, polluted similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the How To Clean Hardwood Engineered Floor is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are hermetically sealed similar to wax. To cut off the white spots, use a piece of fine steel wool lightly dampened similar to wax and rub gently. The last is if you suspect a varnish or shellac, take a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed similar to one of the older ability methods, it will flake off.