To figure out whether or not your wood floors are over and done with later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion middle suggests these tests: First is govern your hand higher than the wood. If you can quality the texture of the grain, the How To Clean Hardwood Floors After Removing Wall To Wall has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, poisoned later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the How To Clean Hardwood Floors After Removing Wall To Wall is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after more or less 10 to 15 minutes, the floors are sealed later wax. To sever the white spots, use a fragment of good steel wool lightly dampened later wax and smooth gently. The last is if you suspect a varnish or shellac, receive a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been sealed later one of the older exploit methods, it will flake off.