To figure out whether or not your wood floors are over and done with past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is govern your hand higher than the wood. If you can tone the texture of the grain, the How To Clean Hardwood Floors And Keep Them Shiny has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, impure past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the How To Clean Hardwood Floors And Keep Them Shiny is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are strong past wax. To cut off the white spots, use a piece of fine steel wool lightly dampened past wax and massage gently. The last is if you suspect a varnish or shellac, receive a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong past one of the older ability methods, it will flake off.