The Best Home Improvement Ideas > Floor > How To Clean Hardwood Floors Before Polyurethane

How To Clean Hardwood Floors Before Polyurethane



How To Clean Hardwood Floors Before Polyurethane

To figure out whether or not your wood floors are over and done with in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is control your hand more than the wood. If you can vibes the texture of the grain, the How To Clean Hardwood Floors Before Polyurethane has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, polluted in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the How To Clean Hardwood Floors Before Polyurethane is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are hermetically sealed in imitation of wax. To remove the white spots, use a piece of good steel wool lightly dampened in imitation of wax and smooth gently. The last is if you suspect a varnish or shellac, admit a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed in imitation of one of the older completion methods, it will flake off.