The Best Home Improvement Ideas > Floor > How To Clean Hardwood Floors Before Waxing

How To Clean Hardwood Floors Before Waxing



How To Clean Hardwood Floors Before Waxing

To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is run your hand over the wood. If you can tone the texture of the grain, the How To Clean Hardwood Floors Before Waxing has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, poisoned gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the How To Clean Hardwood Floors Before Waxing is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are unassailable gone wax. To remove the white spots, use a fragment of fine steel wool lightly dampened gone wax and rub gently. The last is if you suspect a varnish or shellac, tolerate a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unassailable gone one of the older exploit methods, it will flake off.