To figure out whether or not your wood floors are done gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is rule your hand over the wood. If you can vibes the texture of the grain, the How To Clean Hardwood Floors Bona has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, mixed gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the How To Clean Hardwood Floors Bona is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are sealed gone wax. To sever the white spots, use a piece of good steel wool lightly dampened gone wax and smooth gently. The last is if you suspect a varnish or shellac, say yes a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed gone one of the older execution methods, it will flake off.