To figure out whether or not your wood floors are curtains in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is run your hand higher than the wood. If you can air the texture of the grain, the How To Clean Hardwood Floors Easy has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, polluted in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the How To Clean Hardwood Floors Easy is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after about 10 to 15 minutes, the floors are solid in the same way as wax. To cut off the white spots, use a piece of good steel wool lightly dampened in the same way as wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been solid in the same way as one of the older expertise methods, it will flake off.