To figure out whether or not your wood floors are over and done with following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is govern your hand more than the wood. If you can character the texture of the grain, the How To Clean Hardwood Floors For Fleas has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, dirty following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the How To Clean Hardwood Floors For Fleas is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetically sealed following wax. To remove the white spots, use a fragment of fine steel wool lightly dampened following wax and massage gently. The last is if you suspect a varnish or shellac, bow to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed following one of the older achievement methods, it will flake off.