To figure out whether or not your wood floors are finished next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is control your hand beyond the wood. If you can environment the texture of the grain, the How To Clean Hardwood Floors From Glue has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, polluted next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the How To Clean Hardwood Floors From Glue is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after practically 10 to 15 minutes, the floors are hermetic next wax. To separate the white spots, use a piece of good steel wool lightly dampened next wax and daub gently. The last is if you suspect a varnish or shellac, acknowledge a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetic next one of the older completion methods, it will flake off.