To figure out whether or not your wood floors are finished considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is run your hand higher than the wood. If you can environment the texture of the grain, the How To Clean Hardwood Floors Good has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, dirty considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish on the How To Clean Hardwood Floors Good is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are hermetic considering wax. To separate the white spots, use a fragment of fine steel wool lightly dampened considering wax and smooth gently. The last is if you suspect a varnish or shellac, give a positive response a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetic considering one of the older completion methods, it will flake off.