To figure out whether or not your wood floors are ended with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is govern your hand exceeding the wood. If you can tone the texture of the grain, the How To Clean Hardwood Floors Grooves has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, unclean with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the How To Clean Hardwood Floors Grooves is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are hermetically sealed with wax. To sever the white spots, use a piece of good steel wool lightly dampened with wax and massage gently. The last is if you suspect a varnish or shellac, recognize a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed with one of the older carrying out methods, it will flake off.