To figure out whether or not your wood floors are finished later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is direct your hand higher than the wood. If you can setting the texture of the grain, the How To Clean Hardwood Floors Mop has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, unclean later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the How To Clean Hardwood Floors Mop is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after more or less 10 to 15 minutes, the floors are solid later than wax. To remove the white spots, use a fragment of good steel wool lightly dampened later than wax and smear gently. The last is if you suspect a varnish or shellac, consent a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been solid later than one of the older exploit methods, it will flake off.