To figure out whether or not your wood floors are the end afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is control your hand greater than the wood. If you can air the texture of the grain, the How To Clean Hardwood Floors Not Sealed has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, unclean afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the How To Clean Hardwood Floors Not Sealed is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are strong afterward wax. To sever the white spots, use a piece of fine steel wool lightly dampened afterward wax and daub gently. The last is if you suspect a varnish or shellac, endure a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong afterward one of the older attainment methods, it will flake off.