To figure out whether or not your wood floors are done following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is run your hand over the wood. If you can character the texture of the grain, the How To Clean Hardwood Floors Pet Stains has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, dirty following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the How To Clean Hardwood Floors Pet Stains is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are unassailable following wax. To remove the white spots, use a piece of fine steel wool lightly dampened following wax and rub gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unassailable following one of the older feat methods, it will flake off.