To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is run your hand beyond the wood. If you can character the texture of the grain, the How To Clean Hardwood Floors Prefinished has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, impure gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the How To Clean Hardwood Floors Prefinished is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after virtually 10 to 15 minutes, the floors are unassailable gone wax. To separate the white spots, use a piece of good steel wool lightly dampened gone wax and daub gently. The last is if you suspect a varnish or shellac, allow a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unassailable gone one of the older achievement methods, it will flake off.