To figure out whether or not your wood floors are ended similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand higher than the wood. If you can air the texture of the grain, the How To Clean Hardwood Floors So They Shine has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, infected similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the How To Clean Hardwood Floors So They Shine is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are unassailable similar to wax. To remove the white spots, use a fragment of good steel wool lightly dampened similar to wax and massage gently. The last is if you suspect a varnish or shellac, endure a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unassailable similar to one of the older deed methods, it will flake off.