To figure out whether or not your wood floors are ended following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is run your hand on top of the wood. If you can vibes the texture of the grain, the How To Clean Hardwood Floors That Have Been Waxed has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, polluted following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the How To Clean Hardwood Floors That Have Been Waxed is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after virtually 10 to 15 minutes, the floors are hermetically sealed following wax. To surgically remove the white spots, use a piece of fine steel wool lightly dampened following wax and massage gently. The last is if you suspect a varnish or shellac, undertake a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed following one of the older ability methods, it will flake off.