The Best Home Improvement Ideas > Floor > How To Clean Hardwood Floors Using Bona

How To Clean Hardwood Floors Using Bona



How To Clean Hardwood Floors Using Bona

To figure out whether or not your wood floors are done in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is direct your hand greater than the wood. If you can atmosphere the texture of the grain, the How To Clean Hardwood Floors Using Bona has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, infected in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish upon the How To Clean Hardwood Floors Using Bona is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are unquestionable in the manner of wax. To separate the white spots, use a fragment of fine steel wool lightly dampened in the manner of wax and rub gently. The last is if you suspect a varnish or shellac, allow a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable in the manner of one of the older exploit methods, it will flake off.