To figure out whether or not your wood floors are done in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is run your hand greater than the wood. If you can feel the texture of the grain, the How To Clean Hardwood Floors Using Vinegar has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, mixed in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the How To Clean Hardwood Floors Using Vinegar is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are hermetic in the manner of wax. To sever the white spots, use a piece of good steel wool lightly dampened in the manner of wax and rub gently. The last is if you suspect a varnish or shellac, take on a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetic in the manner of one of the older completion methods, it will flake off.