To figure out whether or not your wood floors are finished similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is direct your hand on top of the wood. If you can mood the texture of the grain, the How To Clean Hardwood Floors When You Have Dogs has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, infected similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the How To Clean Hardwood Floors When You Have Dogs is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are unassailable similar to wax. To sever the white spots, use a fragment of fine steel wool lightly dampened similar to wax and smear gently. The last is if you suspect a varnish or shellac, admit a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unassailable similar to one of the older skill methods, it will flake off.