The Best Home Improvement Ideas > Floor > How To Clean Hardwood Floors With Bona

How To Clean Hardwood Floors With Bona



How To Clean Hardwood Floors With Bona

To figure out whether or not your wood floors are ended gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is direct your hand exceeding the wood. If you can tone the texture of the grain, the How To Clean Hardwood Floors With Bona has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, infected gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the How To Clean Hardwood Floors With Bona is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetic gone wax. To cut off the white spots, use a piece of fine steel wool lightly dampened gone wax and smear gently. The last is if you suspect a varnish or shellac, say you will a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetic gone one of the older feat methods, it will flake off.