To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is run your hand higher than the wood. If you can vibes the texture of the grain, the How To Clean Hardwood Floors With Oil And Vinegar has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, impure gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the How To Clean Hardwood Floors With Oil And Vinegar is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are hermetically sealed gone wax. To sever the white spots, use a fragment of fine steel wool lightly dampened gone wax and smear gently. The last is if you suspect a varnish or shellac, believe a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed gone one of the older expertise methods, it will flake off.